Pianos routinely make movers yearly list of items that are most frequently harmed. Grand pianos are particularly troublesome. Practicing the following procedures for dismantling, padding and filling grand pianos will prevent damage, lower claims expenditure, and improve consumer complete satisfaction.
1) At least 3 individuals are needed to manage an infant grand piano. If the infant grand piano requires to go up or down stairs or if a full or performance grand piano needs to be transferred, a minimum of 4 people are needed.
2) Constantly finish a comprehensive and precise inventory. It might be necessary or more suitable to utilize a visual stock to properly describe and reveal pre-existing damage.
3) As numerous parts are dismantled, please location all hardware in a properly labeled parts bag and then put the parts bag in a "Parts Box".
4) Eliminate the music rack (lyre) from its track by pulling it toward the keyboard. Wrap it in a clean furnishings pad.
5) Disconnect the lid by removing the hinge pins. Wrap the cover in a tidy furniture pad.
6) Remove the prop that holds the cover open and wrap it in a tidy furniture pad. The prop has a hinge pin and is in 2 pieces.
7) Remove the pedal assembly and wrap it in a tidy furnishings pad. When eliminating the screws, please be mindful not to drop the braces. As you face the piano, number the push-rods from left to right as "1", "2", and "3", by putting a piece of masking tape with the appropriate number on each rod.
8) Pad the piano by putting a tidy rolled furnishings pad (stretch-wrap the pad to prevent it from unrolling) on the cover of the keyboard to prevent it from flopping open while you manage the piano. Cover the top of the piano with two clean furnishings pads, nicely folded around the keyboard. Usage elastic band to protect the pads. Keep in mind: Please guarantee that the surface area of the piano is dust-free prior to padding it. Padding an extremely sleek surface area that is dirty might trigger fine scratches, particularly on a black lacquer surface.
9) Position a piano board and attach the straps so that it is prepared to receive the piano. The raised brace on the piano board ought to be at the keyboard end of the piano.
10) Get rid of the left front leg by positioning one individual underneath the piano at the left end of the keyboard. Be sure to have 2 people raising the corner of the piano while the third person gets rid of the leg. Note: Please be sure to keep in mind which legs were removed from which positions because some pianos have legs that are not interchangeable.
11) Location the piano on the piano board by reducing the "leg-less" end onto the board. Please be sure to raise the whole piano a little while finishing this maneuver to avoid excessive pressure on the staying, connected legs as the piano ideas. Be sure that the piano is focused snugly against the brace at the end of the piano board.
12) Eliminate the two remaining legs and cover them in tidy furnishings pads. These legs are original site held in place by a "crucial and slot" plan. To get rid of the leg, slide it inward towards the center of the piano up until it comes out of the slot.
13) Secure the piano to the piano board by bringing completions of the straps together and attaching them. Place folded burlap pads over the furniture pads however under the straps to offer additional protection to the edges of the piano. To avoid the strap near the narrow end of the piano from slipping off, tie the loose ends of the 2 straps together.
14) To move the piano over a flat, level surface area, tilt the piano and piano board and place a four-wheel dolly under the center of the piano board.
15) To move the piano up or down stairs, utilize the piano board as a skid. After sufficiently padding the stairs for defense against house damage, position the keyboard end of the piano toward the bottom of the stairs. Connect a hump strap to the leading end of the piano board to prevent the piano from slipping.
16) To fill the piano, leave it on the piano board and place it in a tier as the very first base product with the keyboard facing the wall of the preceding tier. The finest location to load the padded cover is between the piano and the preceding tier or in between the wall and the piano.
Grand pianos represent a significant difficulty, they can be moved without damage by utilizing typical sense and practicing the procedures listed above.